Sorry but this item is currently unavailable.
Please check back at a later stage.
Valve Seal Fitting Sleeves
Fits 11/32" Valves, pack of 10
Once upon a time, these were included with all valve seal sets. Back in the day when old school teflon seals were all the rage, protector sleeves were mandatory because teflon seals would certainly get damaged without a sleeve. The old school teflon seals slowly became obsolete as they were replaced with a better design- the fixed body metal clad viton seal. Within a few years, protector sleeves were no longer included in seal sets and the sleeve supply dried up.
It's always made perfect sense to use a sleeve over the valve stem groove as it guarantees the seal will not get cut from any sharp edges in the groove area.
We've been searching for them for years. In 2013, while at a trade show, we found a German manufacturer who could supply them. We've invested allot of time and money to make seal fitting protector sleeves available once again.
If used with care, these normally last for multiple sets of heads. Every head builder should have a few of each size to assure seals are safely installed.
This listing is for 11/32" sleeves only but we also carry sleeves in the following sizes.
Easy to use. Just slip the sleeve over the valve and slide the seal right over the groove. See pictures for an example of sleeves installed on a few valves.
Thanks for stopping by~